Place it so the tab of the end shingle covers it completely.
Proper roof flashing installation.
Nail metal flashing called drip edge along the bottom edge of the roof deck near the gutters.
The roof deck flange of step flashings are to be fastened to the surface of each shingle in a position whereby the next course of shingles will cover up hide the flashing from view.
When you install roof flashing you will need to use a sealant.
You will also need rake edge flashing for the sides of the roof.
These areas include anywhere there are intersections or joints such as edges around chimneys vents skylights roof valleys and soil stacks.
Two ways to flash roof edges.
The flashing integrates the roof cladding into the wall cladding to keep water out.
While roofing professionals occasionally use nails when flashing they must choose whether to nail to the roof plane or the vertical wall.
Renew flashing seals by chipping out old caulking and mortar along the edges of the flashing.
How to install roof flashing against a wall.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
To install the flashing piece on the first course place it over the end of the starter strip.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
Step flashing redirects the water back onto the shingle.
Fasten loose nails and cover exposed nail heads with roofing cement.
As a protectant flashing is placed anywhere on the roof s surface that requires extra protection.
One common method is to lay the edge metal under the eaves membrane and over the rake.
Protect the eave from ice dams and sideways rain step one in steep slope roofing is the edge flashing.
Proper installation of step flashing.
Make sure to install flashing around the chimneys and walls.
However when flashing crowne slate with its much larger 10 exposure the flashing piece would need to be 10 x 12.
If nailed to both the flashing may deform under the pressure from shifting brick or wood.
Install the step flashing pieces so that they can easily be replaced during a reroof job or else the damaged old.
Secure the horizontal flange to the roof deck using two nails.
Step flashings are to be installed one per course.
