Power Door Lock Not Working On 2008 Dodge Ram

I took the wire harness out and tested it and it works fine.

Power door lock not working on 2008 dodge ram.

Symptom summary the power door locks are all inoperative or a single door lock is inoperative. The switch provides power to the door lock solenoids. Diagnose power door locks don t work properly. Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob.

The most recently reported issues are listed below. Windows can still work but locks will all stop. The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working. For a 10 relay gotta spend 500 1000 dollars to fix power door locks.

Even if you change the acuators the locks still will not work until the code is cleared. All the switches on all four doors will not work either. It runs off a 5 volt reference. What a forked up way to build stuff.

The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators. Average repair cost is 200 at 62 150 miles. The rear window still opens though. Usual cause the power door locks utilize individual solenoids in each of the doors that activate the door lock mechanism.

Power door locks do not work. Posted on sep 25 2008. Dodge ram 1500 owners have reported 2 problems related to power door locks not working under the electrical system category. My power windows on a 2008 dodge ram 1500 will not close.

The most recently reported issues are listed below.